NuTone NP60000 Measure Installation, Prepare The Installation, Installation With Standard

2. MEASURE INSTALLATION

Dimensions for the most common installation are shown below.

The minimum hood distance above cooktop must not be less than 24’’. A maximum of 30” above cooktop is highly recommended for best capture of cooking impurities.

Distances over 30” are at the installer and users discretion.

		Standard
		8 ft. (2.44 m)
		ceiling
Standard 18"	18"
(457 mm) H	(457 mm)
over-cooktop	19"
cabinet	(483 mm)
		Top of wood
		mounting strip
Hood
		RMP Series
		Backsplash
		(optional)
	24"
(610 mm)
		Standard 36"
Cooktop		(914 mm)
		H cooktop HH0028A

INSTALLATION WITH STANDARD 18’’ HIGH OVER-COOKTOP CABINET

3. PREPARE THE INSTALLATION

INSTALLATION WITH STANDARD

12’’ SOFFIT OR OPTIONAL

SOFFIT CHIMNEY RMN SERIES

Remove the installation kit from inside the hood.

Make sure that the following items are included:

-Wood strip

-Installation manual

-Accessories including:

•Filters (Quantity varies depending on range hood width)

•Bag of parts including:

(4)flat head screws #10-2’’, (8) screws #8 x 3⁄4’’, (4) nuts #10-32, (2) wall anchors, (2) washers 3⁄16’’ ID x 3⁄4’’ OD

Parts sold separately:

-Interior blower Model RM325H or RM326H (both include rough-in kit)

-In-line blower assembly HLB3, HLB6, HLB9 or HLB11 (all include transition)

-In-line and exterior blower rough-in plate model 332KR, required for all In-line or Exterior Blowers

-Exterior blower assembly 331H, 332H, 335 or 336

-Halogen lights (120 V, 50 W, PAR 20)

-	Heat lamps (Infrared, 120 V, BR40, 250 W max.)
-	RMP Series Backsplash (optional)	3	4

-RBF Series Baffle filters (optional)

-Transitions, duct, elbows, dampers, wall and roof caps. Refer to pages 4 and 5 for a complete list of venting options

and model numbers.		1	2
Using a Phillips #2 or a Robertson #2 screwdriver, unscrew the
hood from the bottom of crate. Refer to figure beside to locate all
4 screws. Discard these screws and remove hood from wood pallet.	HR0002

- 7 -