NuTone QTXEN080 Connect Wiring, Install Grille, Service Parts, Page, Squeeze grille, each side of

		MODELS QTXEN050 • QTXEN080 •
		QTXEN110 • QTXEN150
		Page 4
CONNECT WIRING	INSTALL GRILLE
	5.	Finish ceiling.
		Install ceiling material. Cut out around housing.
	6.	Attach grille
		to housing.
		Squeeze grille
		springs and insert
		them into slots on
		each side of
		housing.

7. Push grille

against

ceiling. 4. Connect electrical wiring.

Run 120 VAC house wiring to installation location. Use proper UL approved connector to secure house wiring to wiring plate. Connect wires as shown in wiring diagrams.

SERVICE PARTS

Key No.	Part No.	Description	Replacement parts can
			be ordered on our
1	97016466	Housing	website. Please visit us
			at www.nutone.com
2	97016450	Duct Connector-6"
3	98010102	Wiring Plate
4	99170245	Screw, #8-18 X .375 (2 req’d)
5	97016932	Wire Panel/Harness Assembly
6	99020284	Blower Wheel
7	99080560	Motor (QTXEN050)
	99080562	Motor (QTXEN080)
	99080580	Motor (QTXEN110)
	99080565	Motor (QTXEN150)
8	99100491	Isolator (4 req’d)
9	97016468	Motor Plate
10	99250959	Washer #8 (4 req’d)
11	99260558	Nut, Hex Lock #8-32 (4 req’d)	TAB
12	99500397	Insulation (QTXEN150 only)
13	99420648	Threaded Stud (QTXEN150 only) (4 req’d)
14	99260570	Plastic Nut (QTXEN150 only) (4 req’d)
*	97016587	Blower Assembly (QTXEN050)
*	97016588	Blower Assembly (QTXEN080)
*	97016738	Blower Assembly (QTXEN110)
*	97016591	Blower Assembly (QTXEN150)
		(includes key nos. 6 thru 14)
15	99140199	Grille Spring (2 req’d)
16	97016460	Grille Assembly (includes key no. 13)
17	99111293	Spacer (2 supplied)
18	QTNHB1	Hanger Bar Kit

Order service parts by “Part No.” - not by “Key No.”

SERVICE NOTE To remove Blower Assembly: Unplug motor (7). Remove screw (4)
from motor plate (9) flange. Find the single TAB on the motor plate (located next to the
receptacle). Push up near motor plate tab while pushing out on side of housing. Or insert
a straight-blade screwdriver into slot in housing (next to tab) and twist screwdriver.	99043850A