NuTone QTXEN110S Install Grille, Warranty, Finish ceiling, Plug in wiring, Service Note, Page 

MODEL QTXEN110S

INSTALL GRILLE SERVICE PARTS

Page 

6. Finish ceiling.

Install ceiling material. Cut out around housing.

7. Plug in wiring.

Plug wiring into the proper receptacles.

8. Attach grille to housing.

Squeeze grille springs and insert them into slots on each side of housing.

9.Push grille against ceiling.

WARRANTY

NuTone THREE YEAR LIMITED WARRANTY

NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of three years from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED,

Replacement parts can be ordered on our website. Please visit us at www. nutone.com

TAB

SERVICE NOTE

To remove Blower Assembly: Unplug motor (7). Remove screw (4) from motor plate (9) flange. Find the single tab on the motor plate (located next to the receptacle). Push up near motor plate tab while pushing out on side of housing. Or insert a straight- blade screwdriver into slot in housing (next to tab) and twist screwdriver.

INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period, NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND TUBES. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by NuTone), faulty installation or installation contrary to recommended installation instructions.

The duration of an implied warranty is limited to the three-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.

NuTone’S OBLIGATION TO REPAIR OR REPLACE, AT NUTONE’S OPTION, SHALL BE THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPE- CIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation may not apply to you.

This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify NuTone at the address or telephone number stated below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original purchase date.

NuTone, Inc., 4820 Red Bank Road, Cincinnati, OH 45227 (1-800-543-8687)

Key No.	Part No.	Description
1	97016466	Housing
2	97016450	Duct Connector-6”
3	98010102	Wiring Plate
4	99170245	Screw, #8-18 X .375 (2 req’d)
5	97017086	Wire Panel/Harness Assembly
6	99020284	Blower Wheel
7	99080580	Motor
8	99100491	Isolator (4 req’d)
9	97017083	Motor Plate & Control Assembly
10	99250959	Washer #8 (4 req’d)
11	99260558	Nut, Hex Lock #8-32 (4 req’d)
*	97017087	Blower Assembly
12	97016964	(includes key nos. 6 thru 11)
		Grille Assembly
13	99140199	(includes key nos. 13 & 16)
		Grille Spring (2 req’d)
14	99111293	Spacer (2 supplied)
15	QTNHB1	Hanger Bar Kit
16	99271344	Sensor Wire Harness

Order service parts by “Part No.” - not by “Key No.”

99043588B