Ø Troubleshooting
Error 02 – Media Seating Failed
Possible | Media has buckled in the drum. |
|
Cause: |
|
|
Recovery | Load Failure: Select Set Up/Motor Control/All Motors Reverse. Retract 135 |
|
inches of media. |
| |
Methods: |
| |
Advance Failure: Select Media/Cut and Unload. |
| |
|
| |
|
|
|
Error 03 – Excessive Media Slip |
| |
|
|
|
Possible | Load Failure: Leading edge of media has excessive curl or a folded corner. This |
|
will create excessive drag as media travels between the media guides and the |
| |
Cause: |
| |
drum. |
| |
|
| |
|
|
|
Recovery | Load Failure: Select Set Up/Motor Control/All Motors Reverse. Retract 135 |
|
Method: | inches of media. |
|
|
|
|
Error 04 – Infeed Timeout Fault |
| |
|
|
|
Possible | User took too long to feed media into the machine. |
|
Cause: |
|
|
Recovery | Reload media. |
|
Method: |
|
|
Error 05 – Media Guide Location Unknown |
| |
|
|
|
| A) The media has come off the drum surface and is causing drag against the |
|
Possible | movement of the media guides. |
|
|
| |
Causes: | B) The media guides or brushes are dragging against the drum surface. |
|
| C) The media guide sensor is not functioning properly. |
|
|
|
|
| A) Select Media/Cut and Unload. If problem persists call a field service |
|
Recovery | representative. |
|
|
| |
Methods: | B) The media guides have shifted. Contact Océ. |
|
| C) Contact Océ. |
|
|
|
|
see copyright, disclosure, use and duplication information on pg ii |
