5CONNECTING THE UNIT
CAUTION: A
3
1
6.3 Cycle Counter
The cycle counter records the numbers of dispense cycle being activated. Up to 65,535 cycles can be recorded. This number is shown at the lower right hand corner of the LCD. Press the Counter Reset button (3) to clear the counter.
7 TROUBLESHOOTING
2
4
Figure 2.0
Items | Description |
1 | To Air Source |
2 | Air Filter (Not included) |
3 | Power Adapter |
4 | Foot Switch |
6SETUP INSTRUCTIONS Refer to Figure 1.0
6.1Manual Dispense Cycle Setting:
1.Turn on the unit by pressing the Power button (1)
2.Press the Mode button (2) until “PURGE” appears on the Display.
3.Turn up the air pressure by rotating the Air pressure regulator knob (6) until the desired pressure is indicated on the Air pressure gauge (5)
4.After filling the barrel or using
5.Connect the plug end of the receiver head assembly to one of the air dispense outlet (7)
6.If vacuum “suck back” is needed, rotate the Vacuum regulator (8) counter clockwise until the desired vacuum pressure is obtained
7.Press and hold the Foot switch to activate dispensed cycle. (The Purge/Manual Mode is now activated)
6.2Automatic Dispense Cycle Setting:
1.Push the Mode button (2) to select “TIMED” mode
2.Rotate the Time control knob (9) to set desired dispense time
3.Repeat step 3 to 6 in Section 6.1
4.Depress Foot switch to activate timed dispensed cycle
PROBLEM
LCD does not light
System will not actuate
System will not pressurize
System will not pull vacuum
Inconsistent dispensing
POSSIBLE CAUSE | CORRECTION | ||
• | No power input | • | Check power cord |
|
| • | connections |
|
| Turn on power | |
• | Foot switch not | • | Check foot switch |
| plugged in or |
| connection |
| improperly plugged |
|
|
• | in | • |
|
Defective foot | Foot switch needs to be | ||
• | switch | • | repaired or replaced |
Broken wire or loose | Unplug power cord and | ||
| connection inside |
| disconnect air supply. |
| unit |
| Remove cover and check |
|
|
| for broken wires or loose |
• | Defective solenoid | • | connections |
Replace solenoid | |||
• | Defective PC board | • | Replace PC board |
• | Insufficient air | • | Increase air supply |
• | pressure | • | pressure |
Air hoses not | Check connection | ||
• | plugged in | • |
|
Regulator defective | Replace regulator | ||
• | Vacuum setting is | • | Increase vacuum setting |
• | too low | • |
|
Defective solenoid | Replace solenoid valve | ||
• | Defective vacuum | • | Replace venture |
• | venturi | • |
|
Defective vacuum | Replace needle valve | ||
| needle valve |
|
|
• | Air bubbles in | • | Reduce vacuum setting |
• | adhesive | • |
|
Dispense time is too | Increase dispensing time | ||
• | low | • |
|
Dispense needle | Replace needle | ||
| started to clog |
|
|
5
6