Oki 1.2 - page 50

42 Setup

Item Description Default

Inter digit To set the time-out value of the telephone number entries. 4 sec.

time-out If time-out occurs the system determines that all numbers

have been entered and commences to generate the call.

Ringer frequency Specifies the ringer frequency. 20 Hz

Howler tone Specifies the time for sending the howler tone. 30 sec.

send time

Ringing time Specifies the ringer sounding time intervals for incoming ON1=1000 ms

calls from the VoIP line and PSTN line respectively. OFF1=2000 ms

See the figure below for a graphic explanation. ON2=1000 ms

OFF2=2000 ms

Hookflash To set the minimum and maximum time interval for the Min.=96 ms

detection time Hookflash detection. When an on-hook state exists in the Max.=768 ms

time interval between the specified minimum (Min.)

and maximum (Max.), a hooking condition is determined.

Detailed settings can be made for telephone and facsimile units

connected to the VoIP-TA unit.

SLIC setting

The default values, set at the time of product shipping, are displayed

when the Restore defaultbutton is clicked.

Contents

Main Page Page Contents Important Safety Instructions v Introduction vii I Outline 1 II Installation 5 III Placing Calls 8 IV Setup 17 Important Equipment Information 50 Warranty and Service 51 Oki Service Offices 52 Important Safety Instructions Page Introduction Welcome to the world of Oki Internet telephony I Outline The VoIP-TA Features Front Panel LEDs Back Panel Connectors Table 1 Page Page Cautions During installation During use III Placing Calls Via an IP Network General Operation Services Third party incoming call during another call Page Page Absent service Details of Services Using both a PSTN line and the IP network Page Page Page IV Setup Maintenance Console Software Requirements Installing the Maintenance Console Software Maintenance Console Software Compatibility Functions of the Maintenance Console Software Data Setup Procedure Activating and Deactivating the Softwares Functions Page Changing Modes and Setup Conditions Changing to the Setup mode Changing setup conditions Saving all setup conditions in a file Page Setup (VoIP-TA setting)Window Basic settings for the PSTN line Page Example VoIP-TA will operate in the following way when the internal address table is used. Page Page Page Page Page Page Gatekeeper settings Detailed gatekeeper settings Address table Page Details Voice settings Voice codec setting and bandwidth used G.729A G.723.1 G.711 Page Page V Maintenance Functions of the Maintenance Console Software Verifying the Software Version Information Checking the Operation Status of the VoIP-TA Explanation of the displayed information Click the Close button. Updating Unit Programs Changing the password VI Troubleshooting VII Specifications Protocol and service port number used with the VoIP-TA. Note Important Equipment Information Warranty and Service Warranty Period Following the warranty period Oki Service Offices Head Office London Office Sydney Office Oki Network Technologies