4.Adjust the paper feed guides ( ) for the width of the paper and drop a sheet of paperÀinÀto the separator.
The paper will automatically feed into the printer, and the printhead will move back and forth, gently firing the pins to sense the paper thickness and set the printhead gap.
If the paper doesn’t feed in properly, the “15” light
4on the control panel will begin flashing. To correct this, press the SHIFT and RESET buttons simulta- neously, then reload the sheet.
5. Check the baseline for the Top of Form (TOF), indi- cated by the red line on the clear plastic paper shield ( ).
Õ 
Õ
If it’s OK, press the SEL button and you’re ready to start printing. If it needs adjustment, set the Top of Form following the instructions on the next page.
