Oki 80 Series warranty Character Sets, Cut Sheet Feeder

Character Sets

ASCII	Decimal	Hexadecimal	Character Set
ESC 6	27 54	1B 36	II
ESC 7	27 55	1B 37	I

If you use Spanish for all your documents it is better to make the selection on the internal switches so that the printer normally uses that language.

Cut Sheet Feeder

ASCII	Decimal	Hexadecimal
ESC EM I	27 25 73	1B 19 49
ESC EM R	27 25 82	1B 19 52

If you are printing program outputs using the Cut-Sheet Feeder, you must include the Cut-Sheet Feeder insert and eject commands. When the printer receives the PRINT command, it inserts a sheet of paper and starts printing. Each time the printer receives the Cut-Sheet Feeder insert command, it ejects the printed sheet then inserts a new sheet. Use the Cut-Sheet Feeder eject command at the end of your program if you want the printer to eject the printed sheet without inserting a new sheet.

You can use the CHR$(27); CHR$(25); “I” command to insert a new sheet of paper from the hopper. If paper is already in the printer this sheet will be ejected first before the new sheet is fed in. (In normal use this is achieved by using the FF code).

Should you wish to eject a sheet then use the CHR$(27); CHR$(25); “R” command.

Note: A LF command at the end of a page also causes the next sheet to be loaded.

3 – 20 Programming