Oki 8p Plus setup guide Connecting the data cable, English, Connecting the USB cable

Connecting the data cable

The printer comes with a standard high speed bidirectional IBM Centronics compatible parallel data interface as standard. This requires a IEEE1284 compliant parallel printer cable, not more than 1.8m in length.

1 Connect one end of the parallel data cable (36-pin Centronics) to the printer’s data interface (1).

1

2Connect the end containing the standard DB25 connector to the host PCs parallel data port (usually designated as LPT1).

Connecting the USB cable	English
The printer comes with a USB interface as standard. This requires
a Type A to Type B cable, not more than 5m in length.

1Connect the Type B (square) connector on the cable to the USB interface connector at the rear of the printer (1).

2Connect the Type A (small, flat) connector on the other end of the cable to the host PC’s USB port.

See ‘Installing the USB Printer Driver’ for further information on USB installation.

1

Setup Guide 13