Menu functions - C830 > 52
C
ALIBRATION
Change
Password
New
Password
xxxxxxxxxxxxxx Sets a new password to enter Admin Setup menu
From 6 to 12 alpha/numeric digits can be entered.
Verify
password
xxxxxxxxxxxxxx Forces the User to input the new password to enter Admin
Setup.
From 6 to 12 alpha/numeric digits can be entered.
Settings Reset
Settings
Execute Resets EEPROM of CU. Resets User menu to the factory
default.
If Execute is selected, exits from the menu.
Save
Settings
Execute Saves menus currently set. With this function, the menus
with which operation was last performed are saved, and
overwrites with them menus that were previously saved.
When the Enter button is pressed, the following
confirmation message appears.
Are You Sure? Yes/No
When No is selected, the preceding menus are restored.
When Yes is selected, the current menu settings are
saved and this menu is exited.
ITEM SETTINGS EXPLANATION
Auto Density
Mode
On/Off Enables/disables automatic de nsity adjustment.
Adjust Density Execute If Execute is selected, the printer will immediately
adjust density and reflect it in TRC compensation.
This adjustment must be executed when the
printer is idling. It can become invalid if executed
in any other state.
Adjust
Registration
Execute When this menu is selected, the printer performs
AutoAdjust Registration.
This adjustment must be executed when the
printer is idling.
Print Tuning
Pattern
Execute Prints the pattern for the user to adjust TRC.
Ordinarily, this function is not needed because TRC is
automatically adjusted to the recommended levels
through density adjustment and TRC compensation.
Adjustment results will be reflected as offset values
(addition) to the corrections through the Adjust
Density/TRC Compensation function.
Cyan/Magenta/
Yellow/Black
Tuning
Highlight -3,-2,-1,
0,+1,+2,+3,
Adjusts HIGHLIGHT (light area) of the TRC.
+ = Darker
- = Lighter
Mid-Tone -3,-2,-1,
0,+1,+2,+3,
Adjusts MID-TONE area of the TRC.
+ = Darker
- = Lighter
Dark -3,-2,-1,
0,+1,+2,+3,
Adjusts DARK area of the TRC.
+ = Darker
- = Lighter
Cyan/Magenta/
Yellow/Black
Darkness
-3,-2,-1,
0,+1,+2,+3,
Adjusts the engine density.
The Darkness settings for each of CMYK will be
reflected as offset values (addition) to the corrections
through the Adjust Density/TRC Compensation
function.
ITEM SETTINGS EXPLANATION