
This menu controls the operation of the printer’s USB data interface.
ITEM | SETTINGS | EXPLANATION |
|
|
|
SOFT RESET | ENABLE / | Enables or disables the SOFT RESET |
| DISABLE | command. |
|
|
|
SERIAL NUMBER | ENABLE / | Specifies whether to ENABLE or DISABLE |
| DISABLE | a USB serial number. |
|
| The USB serial number is used to identify |
|
| the USB device connected to your PC. |
SPEED | 12 / 480 Mps | Selects the interface speed |
NOTE:
When you have changed any settings in the USB MENU, turn the printer OFF, then ON again.
NETWORK MENU
This menu controls the operation of the printer’s
ITEM | SETTINGS | EXPLANATION |
|
|
|
TCP/IP | ENABLE / | Enables or disables this network protocol. |
| DISABLE |
|
|
|
|
NETBEUI | ENABLE / | Enables or disables this network protocol. |
| DISABLE |
|
IP ADDRESS SET | AUTO / MANUAL | Specifies whether IP address allocation is |
|
| automatic (DHCP) or manually assigned. |
|
|
|
IP ADDRESS | xxx.xxx.xxx.xxx | Current assigned IP address. To change, |
|
| press ENTER and use +/– buttons to |
|
| increment 1st octet, then press ENTER |
|
| again to move on to next octet. When 4th |
|
| octet has been set, press ENTER again to |
|
| register new address. |
SUBNET MASK | xxx.xxx.xxx.xxx | Current assigned subnet mask. To |
|
| change, proceed as above. |
|
|
|
GATEWAY | xxx.xxx.xxx.xxx | Current assigned gateway address. To |
ADDRESS |
| change, proceed as above. |
FACTORY | EXECUTE | Reloads the settings present when the |
DEFAULTS |
| unit was setup by the manufacturer. |
|
|
|
WEB | ENABLE / | Enables or disables Web config. facility. |
| DISABLE |
|
TELNET | ENABLE / | Enables or disables Telnet config. facility. |
| DISABLE |
|
Menu functions> 75