EN5
En
6Jumping into the water with the Case in your pocket or in your hand,
throwing the Case from a boat or ship into the water, and other rough
handling may cause water leakage. Please handle with sufficient care,
when handing it over from hand to hand etc.
7If the camera on the inside should become wet because of water
leakage etc., immediately wipe off all moisture and confirm the
operation after the Case is dried.
8Please remove the O-ring when traveling by air. Otherwise air
pressure may make it impossible to open the Case.
9For safe use of the digital camera in this product, please read the
“Instruction Manual” for the digital camera carefully.
0When sealing this product, take sufficient care that no foreign matter
gets caught at the O-ring and the contact surface. It is c aused for water
leakage.
aWhen you install your digital camera in the Case after taking pictures
in the water, it may cause the loss of transparency of the lens inside
even if you insert the supplied silica gel to the Case when drying the
camera is insufficient.
Chemicals which cannot
be used Explanation
Volatile organic solvents,
chemical detergents Do not clean the Case with alcohol, gasoline,
thinner or other volatile organic solvents or with
chemical detergents etc. Use pure water or
lukewarm water.
Anticorrosion agent Do not use anticorrosion agents. The metal parts
use stainless steel or brass. Wash with pure
water.
Commercial defogging
agents Do not use commercial defogging agents. Always
use the specified desiccant silica gel.
Grease other than
specified silicone grease Use only the specified silicone grease for the
silicone O-ring, as otherwise the O-ring surface
may deteriorate and water leakage may occur.
Adhesive
Do not use adhesive for repairs or other purposes.
When repair is required, please contact a dealer or
a service station of OLYMPUS IMAGING CORP.
PT-048_EN.book Page 5 Friday, December 11, 2009 4:37 PM