Olympus E03 Removing the TTL cable connector cap

EN 12
En
Removing the TTL cable connector cap
To perform TTL flash shooting in combination with the separately available Electronic Flash Case,
remove the TTL cable connector cap as described below.
How to attach the TTL cable connector cap to the case
Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable
connector. To secure the cap, gently turn it clockwise until it stops.
* For details on the TTL cable and hot shoe cable, refer to the instruction manual provided with the Electronic
Flash Case.
1Remove the TTL cable connector cap
from the Case.
2Connect the Electronic Flash Case’s
underwater TTL cable to the TTL
connector on the Case.
CAUTION:
If the TTL cable connector cap is loose, water penetration may result. Be sure to gently turn the cap until it
stops to make sure it is firmly secured.
Do not turn or tighten the TTL cable too hard. If it is too tight, it may be difficult to loosen and remove.
1Turn counter
clockwise.
TTL cable connector
cap
2Remove.
Underwater TTL
cable
Use this mark to
align the position.
3Insert into the
connector.
4Turn the threaded
section of the
connector clockwise
lightly until it stops.
Check O-rings
Cap Connector
2Gently turn the cap
clockwise until it
stops.
1Attach the cap to
the case.
PT-E03_EN.Book Page 12 Tuesday, March 20, 2007 7:21 PM