Olympus MAUSB-10 1 Connecting to the computer

21
Operating the MAUSB-10
The operating procedures for the MAUSB-10 under Windows 2000/XP are described below.
1 Connecting to the computer <2000/XP ⽧ Operation>
After installing the device driver, connect the MAUSB-10’s connector to the USB port on your computer. (You
can plug in the USB connector while the computer is in use.)
[Notes]
•Be sure to connect the MAUSB-10 to your computer AFTER installing the device driver.
•Make sure the connector is fully inserted.
•When inserting the connector, make sure it is oriented correctly (refer to the pictures below). Inserting the
connector incorrectly may damage the connector and/or the computer’s USB port.
USB port
(Type A)
The computer’s
USB port has a
mark over it.
Installing the new hardware
The first time the MAUSB-10 is connected to your computer, the “Found New Hardware Wizard” window
appears.
Log on with the user name “Administrator”, or use a user name with administrator privileges, then follow the
steps under [Installing the hardware] on the next page. Once the driver is installed, you only need to perform
step 6 on the next page.
[For Windows 2000]
If you do not log on with the user name
“Administrator”, or if you do not use a user name
with administrator privileges, the window at right
appears and you cannot install the driver. Check
the administrator’s name and password, then log
on again.
[For Windows XP]
If you do not log on with the user name
“Administrator”, or if you do not use a user name
with administrator privileges, the window at right
appears. Enter the correct user name and pass-
word then click “OK”.