E-4E-3Batteries
●To supply power to the electronic flash, we recommend you use
two LR6 alkaline batteries, two lithium batteries, two Ni-Mn
batteries, two Ni-Mh batteries or two Ni-Cd batteries.
●Keep the batteries’ contacts away from damp and humidity to avoid
impairing performance and/or causing an accident.
●For other battery handling precautions, please read the relevant
sections in the electronic flash’s instruction manual.
5. Rough handling, such as jumping into the water with the case in
your hand or in an outside pocket or throwing the case into the
water could lead to water penetration. Please always take care
when using the case.
6. If the electronic flash contained in the case gets wet, wipe off all
moisture immediately and check the flash is working correctly.
7. Before traveling by air, please make sure you remove the O-rings,
otherwise the difference in air pressure may make it impossible to
open the case.
8. To ensure safe and trouble-free handling and operation of the
electronic flash in this product, please read the flash’s instruction
manual carefully.
9. When sealing this product, please take care to ensure no foreign
matter such as sand, dirt or hair is on the O-rings or contact
surfaces.
10.
Before storing this product, always be sure to take out the flash.
11.
When using this product, do not fire the flash at close range to a
person or animal.
For Prevention of Water Leakage Accidents
If water gets inside this product during use, irreparable damage may
be caused to the electronic flash inside the case. Please note the
following points.
1. When sealing this product, make sure that no hairs, fibers, sand
particles or other foreign matter stick not only to the O-ring, but
also to the contact surface. Even a single hair or a single grain of
sand may cause water leakage. Please check with special care.
2. The O-ring is a consumption product. Please replace it at least
once a year by new one. Also perform maintenance for every use.
3. Deterioration of the O-ring will progress according to the use
conditions and the storage conditions. Immediately replace the O-ring
by a new one if it is damaged, shows cracks, or has lost its elasticity.
4. At the time of O-ring maintenance, clean the inside of the O-ring
groove and confirm the absence of dirt, dust, sand, and other
foreign matter.
5. Apply the specified silicone O-ring grease to the O-ring.
6. The waterproof function is not effective when the O-ring is not
installed correctly. When installing the O-ring, take care that it does
not project from the groove and that it is not twisted. Also, when
sealing the Case, close the lid after confirming that the O-ring has
not come out of the groove.
7. This product is an airtight construction made of plastic (polycarbonate).
When it is left for a long time in a car, on a boat, at the beach, or at
other places reaching a high temperature, or when it is subjected for a
long time to uneven external force, it may be deformed and the
waterproof function may be lost. Pay sufficient attention to temperature
control. Also do not place heavy objects onto the product during
storage or transport, and avoid unreasonable storage.
8. When the O-ring contact surface is pressed strongly from the
Examples for foreign matter sticking to the O-ring
Hair Fibers Grains of sand