Olympus PT-019 Batteries

5.Jumping into the water with the Case in your pocket or in your hand, throwing the Case from a boat or ship into the water, and other rough handling may cause water leakage. Please handle with sufficient care, when handing it over from hand to hand etc.

6.If the camera on the inside should become wet because of water leakage etc., immediately wipe off all moisture and confirm the operation.

7.Please remove the O-ring when traveling by air. Otherwise air pressure may make it impossible to open the Case.

8.For safe use of the digital camera in this product, please read the "Instruction Manual" for the digital camera carefully.

9.When sealing this product, take sufficient care that no foreign matter gets caught at the O-ring and the contact surfaces.

Batteries

●When using this product, only the LCD monitor of the camera and not the optical viewfinder can be used. As a result, more battery power is used than when shooting with the LCD monitor turned off.

●Please use one Olympus lithium ion rechargeable battery for cameras (LI-10B).

●Batteries are subject to self-discharging. Therefore, always charge up batteries fully before use.

●Take care that the battery electrodes do not become wet. This may cause trouble or accidents.

●Carefully read the instruction manual for the camera about other cautions regarding batteries.

E-3

Contents

Page Introduction Please read the following items before use For safe use Page Batteries For Prevention of Water Leakage Accidents Handling the Product Page Contents Contents Preparations 2.Advance Check of the Case …………………………E-14 3.Install the digital camera. ………………………………E-15 4. Taking Pictures Under Water …………………………E-22 5. Handling After Shooting ………………………………E-23 6. Maintaining the Waterproof Function ……………E-26 Appendix 1. Preparations Check the contents of the package PT-019 Names of the parts Install the strap Master the basic operation Holding the Case How to Press the Shutter How to Use the Mode Dial How to Use the Zoom Lever Setting the Zoom Lever Power Switch Operation Method 2. Advance Check of the Case Advance test before use Advance Test 3. Install the digital camera Check the digital camera Battery Confirmation Confirmation of the Remaining Number of Pictures to be Taken Loading in the Case Open the Case Pull the mode dial of the Case Load the digital camera Set the mode dial Insertion of silica gel Check the loading status Seal the Case Install the special balance weight Installation and Removal of the LCD Hood Installation Removal Mounting and Removing the Lens Cap Perform the final checks Visual Inspection Set the power to 'ON Try to move the mode dial Final Test 4. Taking Pictures Under Water How to Use the Hand Strap Take pictures carefully Confirm the picture on the LCD monitor Quietly press the shutter lever 5. Handling After Shooting Wipe off any waterdrop Take out the digital camera Wash the Case with pure water Dry the Case 6. Maintaining the Waterproof Function Remove the O-ring Remove any sand, dirt, etc Install the O-ring How to Apply Grease to the O-ring Replace consumable products 7. Appendix Q & A on the use of the PT-019 Page Page Page Page After-saleService Specifications