Omega Vehicle Security PTC900 manual Table of Contents, General Meter Specifications

TABLE OF CONTENTS

General Meter Specifications	4	Wiring the Meter	. 7
Optional Plug-In Cards and Accessories . . . .	5	Reviewing the Front Buttons and Display . . 10
Installing the Meter	6	Programming the Meter	11
Setting the Jumpers	6	Factory Service Operations	26
Installing Plug-In Cards	7	Programming Overview	29

GENERAL METER SPECIFICATIONS

1.DISPLAY: 6 digit, 0.56" (14.2 mm) red sunlight readable or standard green

LED

2.POWER:

AC Versions (PTC901, PTC900):

AC Power: 85 to 250 VAC, 50/60 Hz, 18 VA

Isolation: 2300 Vrms for 1 min. to all inputs and outputs. (300 V working) DC Versions (PTC901-LV, PTC900-LV):

DC Power: 11 to 36 VDC, 14 W

(Derate operating temperature to 40°C if operating <15 VDC and three Plug-in cards are installed)

AC Power: 24 VAC, ± 10%, 50/60 Hz, 15 VA

Isolation: 500 Vrms for 1 min. to all inputs and outputs (50 V working)

3.SENSOR POWER: 12 VDC, ±10%, 100 mA max. Short circuit protected.

4.ANNUNCIATORS:

TMR - Timer Display	SP1 - Setpoint 1 Output
CNT - Cycle Counter Display	SP2 - Setpoint 2 Output
DAT - Real-Time Clock Date Display	SP3 - Setpoint 3 Output
- Real-Time Clock Time Display	SP4 - Setpoint 4 Output

5.KEYPAD: 3 programmable function keys, 5 keys total.

6.TIMER DISPLAY:

Timer Range: 23 Selectable Ranges

Timing Accuracy: ± 0.01%

Minimum Digit Resolution: 0.001 Sec.

Maximum Least Significant Digit Resolution: 1 Hr.

Maximum Display: 999999

7.CYCLE COUNTER DISPLAY: Counter Range: 0 to 999999 Digit Resolution: 1 cycle Maximum Count Rate: 50 Hz

8.REAL-TIME/DATE DISPLAY (PTC901): Real-Time Display: 5 display formats

Hr/Min/Sec (12 or 24 Hr. format); Hr/Min (24 Hr.); Hr/Min (12 Hr. with or without AM/PM indication)

Date Display: 7 display formats

Month/Day or Day/Month (numeric or 3-letter Month format); Month/Day/Year or Day/Month/Year (all numeric);

Day of Week/Day (3-letter Day of Week format)

9.REAL-TIME CLOCK CARD: Field replaceable plug-in card

Time Accuracy: ± 5 secs./Month (1 min./year) with end-user calibration

Battery: Lithium 2025 coin cell

Battery Life Expectancy: 10 yrs. typical

Synchronization Interface: Two-wire multi-drop network (RS485 hardware), 32 units max., operates up to 4000 ft.

Isolation To Timer & User Input Commons: 500 Vrms for 1 min. Working Voltage: 50 V. Not isolated from all other commons.

10.TIMER INPUTS A and B:

Logic inputs configurable as Current Sinking (active low) or Current Sourcing (active high) via a single plug jumper.

Current Sinking (active low): VIL = 0.9 V max., 22KΩ pull-up to +12 VDC.

Current Sourcing (active high): VIH = 3.6 V min., 22KΩ pull-down, Max. Continuous Input: 30 VDC.

Timer Input Pulse Width: 1 msec min.

Timer Start/Stop Response Time: 1 msec max.

Filter: Software filtering provided for switch contact debounce. Filter enabled or disabled through programming.

If enabled, filter results in 50 msec start/stop response time for successive pulses on the same input terminal.

11. USER INPUTS: Three programmable user inputs

Logic inputs configurable as Current Sinking (active low) or Current Sourcing (active high) through a single plug jumper.

Current Sinking (active low): VIL = 0.9 V max., 22KΩ pull-up to +12 VDC.

Current Sourcing (active high): VIH = 3.6 V min., 22KΩ pull-down, Max. Continuous Input: 30 VDC.

Isolation To Timer Input Common: Not isolated

Response Time: 10 msec

12.MEMORY: Non-volatile E2PROM retains all programming parameters and display values.

13.ENVIRONMENTAL CONDITIONS:

Operating Temperature Range: 0 to 50°C (0 to 45°C with all three plug-in cards installed)

Storage Temperature Range: -40 to 60°C

Operating and Storage Humidity: 0 to 85% max. RH non-condensing

Vibration According to IEC 68-2-6: Operational 5 to 150 Hz, in X, Y, Z direction for 1.5 hours, 2 g’s.

Shock According to IEC 68-2-27: Operational 25 g (10g relay), 11 msec in 3 directions.

Altitude: Up to 2000 meters

14.CERTIFICATIONS AND COMPLIANCE:

SAFETY

UL Recognized Component, File # E313607, UL61010A-1, CSA C22.2 No. 61010-1

Recognized to U.S. and Canadian requirements under the Component Recognition Program of Underwriters Laboratories, Inc.

UL Listed, File # E313547, UL508, CSA C22.2 No. 14-M95 LISTED by Und. Lab. Inc. to U.S and Canadian safety standards Type 4X Enclosure rating (Face only), UL50

IEC 61010-1, EN 61010-1: Safety requirements for electrical equipment for measurement, control, and laboratory use, Part 1.

IP65 Enclosure rating (face only), IEC 529 IP20 Enclosure rating (rear of unit), IEC 529

ELECTROMAGNETIC COMPATIBILITY

Immunity to EN 50082-2
Electrostatic discharge	EN 61000-4-2 Level 3; 8		Kv air
Electromagnetic RF fields	EN 61000-4-3	Level 3; 10 V/m
		80 MHz - 1 GHz
Fast transients (burst)	EN 61000-4-4	Level 4; 2	Kv I/O
		Level 3; 2	Kv power
RF conducted interference	EN 61000-4-6	Level 3; 10 V/rms
Emissions to EN 50081-1		150 KHz - 80 MHz
RF interference	EN 55022 Enclosure class B
		Power mains class B

Note:

Refer to the EMC Installation Guidelines section for more information.

15.CONNECTIONS: High compression, cage-clamp terminal block Wire Strip Length: 0.3" (7.5 mm)

Wire Gage: 30-14 AWG copper wire

Torque: 4.5 inch-lbs (0.51 N-m) max.

16.CONSTRUCTION: This meter is rated for NEMA 4X/IP65 outoor use. IP20 Touch safe. Installation Category II, Pollution Degree 2. One piece bezel/case. Flame resistant. Synthetic rubber keypad. Panel gasket and mounting clip included.

17.WEIGHT: 10.1 oz. (286 g)

4