Step 14 – Remote Control Programming (English)
EN
ATTENTION!
Must set WALL DETECT RIGHT first. Failure to do this may result in poor performance of Wall Mount. If set LEFT WALL DETECT, please use the SETUP / RESET to clear memory.
EN
STEP 1 = SETUP
Clears Memory & Set Home - Push & Collapse the Mount Flat against the Wall at 0 degrees, Press and Hold for 5 seconds to set the home position (note: this also clears all memorized commands)
LED LIGHT
EN Flashing LED: Transmitting Signal
Solid Color LED: Memory Set or Cancelled
STEP 3 = WALL LIMIT
LEFT SETUP
Swivel Left closest to the Wall without the TV
EN touching the Wall, leave about 1” (25mm). Hold down Wall Detect for 5 seconds till LED LIGHT color turns solid.
EN LEFT SWIVEL
STEP 4 = MEMORY 1 (optional):
Swivel / Tilt to Desire EN Position and Hold for 5
Seconds until LED LIGHT color turns sold, memory is set.
EN TILT DOWN
!
CAUTION
EN TILT UP
STEP 2 = WALL LIMIT
RIGHT SETUP
Swivel Right closest to the Wall without the TV
EN touching the Wall, leave about 1” (25mm). Hold down Wall Detect for 5 seconds till LED LIGHT color turns solid.
EN RIGHT SWIVEL
STEP 5 = MEMORY 2 (optional):
Swivel / Tilt to Desire EN Position and Hold for 5
Seconds until LED LIGHT color turns sold, memory is set.
| HOME |
| This will bring the wall |
| mount back to the wall of |
EN | HOME position that user |
setup, if user needs to set | |
| a different Home position, |
| please refer to SETUP |
| button above for details. |
EN
ATTENTION!
Power Loss or interruption DOES NOT delete or clear the memory. User must use the SETUP / RESET button to clear memory. If Swivel too far RIGHT or LEFT and hits / makes contact with the wall, the unit will Stop after 2 seconds.
