2-2-2 BUM150S connection procedure / Connectable UPS : BU150SW
(1)Connect the end of the battery cable connected to the back of the BUM150S to the UPS additional battery connector and additional battery signal connector.
When a 1050W device is connected, the backup time is 20 minutes (initial battery value at an ambient tem- perature of 20°C).
When the battery is completely discharged, it takes 24 hours to charge.
UPS
(2) Turn ON the overcurrent protection switch on the back of
信号カード 増設
the additional battery unit.
RS232C
AC入力
過電流保護 20A
INPUT
バッテリ増設コネクタ冷却ファン DC36V/40A
BUM150S |
| |
Overcurrent | ON | OFF |
protection switch | ||
Additional battery 
connector 
バッテリ増設信号コネクタ
接地
OUTPUT
出力電力 最大1.5kVA / 1500W
Additional battery signal connector | Battery connection cable |
2-2-3 BUM300S connection procedure / Connectable UPS : BU3002SW
(1)Connect the battery connection cable to the battery connectors on the rear side of the unit and UPS. Connect the signal connection cable to the additional battery signal connector also.
(2)Turn ON the overcurrent protection switch on the back of the battery unit. Connect the AC input plug of the unit to a wall outlet. The additional battery lamp on the unit's operation panel turns ON.
When a 2100W device is connected, the backup time is 24 minutes (initial battery value at an ambient temperature of 20°C).
When the battery is completely discharged, it takes 24 hours to charge.
UPSBUM300S
Additional battery connection
Additional battery signal connection
Battery connection cable
Additional battery connection
Additional battery signal connection
Overcurrent protection
switch ON
OFF
8
