5. Cleaning and daily disinfecting
5.1Cleaning
Following the cleaning instructions after each use will prevent any remaining medication in the tank from drying, resulting in the device not nebulising effectively and also for preventing infections.
Warning:
Thoroughly rinse the nebuliser kit and the mask, nosepiece or mouthpiece with clean hot tap water after each use, and disinfect the parts of the nebuliser kit and applicable inhalation attachments after the last treatment of the day.
Note: Do not start operation before the cleaned parts are completely dried.
1.Make sure that the power switch is in the off ( 
) position.
2.Disconnect the AC adapter from the wall outlet and the compressor.
3.Remove the nebuliser kit from the air tube and disassemble the nebuliser kit. Refer to Section 3 (page
4.Discard any remaining medication in the
medication tank.
5.Wash all the nebulising parts in warm water and mild detergent and rinse in clean hot tap water.
For instructions on how to disinfect the parts, see the following section.
6.After cleaning and disinfecting the parts, rinse them thoroughly with clean water and allow the parts to air dry in a clean environment.
EN
17
