Omron Functions, Interface Cable, V600-HAR91/-HAR81 Read-only type, V600-HAR92 Read-only type

	Type	Read-only (8-bit)		Multi-functional (8-bit)		Read-only (16-bit)
Item	Model	V600-HAR91	V600-HAR81	V600-HAM91	V600-HAM81	V600-HAR92
Vibration resistance		Destruction: 10 to 150 Hz, 0.3-mm double amplitude, with 4 sweeps of 8 min each in				Destruction: 10 to 150 Hz, 1.5-mm
		3 directions				double amplitude, with 4 sweeps
						of 8 min each in 3 directions
Shock resistance		Destruction: 294 m/s2, 3 times each in 6 directions
Ambient temperature		−10 to 55°C (with no icing)
Ambient humidity		35% to 85% (with no condensation)
Storage temperature		−25 to 65°C
Degree of protection		IEC60529: IP40
Ground		Ground to 100 Ω or less.
Material		ABS resin (case)
Cable length		Standard, 0.5 m with a dedicated connector (See note.)
Weight		Approx. 170 g				Approx. 180 g

Note: The connector is not waterproof. If there is a possibility that the connector may be exposed to water, keep it inside the control box. Be sure to use the connector together with the separately sold interface cable.

■Functions

V600-HAR91/-HAR81 (Read-only type)

Reads the 8-bit data (1 byte) of the set address and outputs to the 8 data output lines.

Write

Writes on the set address the 8-bit (1 byte) data designated via the 8 data input lines.

V600-HAM91/-HAM81 (Multi-functional type)

The amplifier has the following three basic functions.

Read

Reads the 8-bit (1 byte) data of the set address and outputs to the 8 data output lines.

Verify

Reads the 8-bit data (1 byte) of the set address, compares with the 8- bit (1 byte) data input via the 8 verification data input lines, and out- puts the verification result.

V600-HAR92 (Read-only type)

Reads the 16-bit data (2 bytes) of the set address and outputs to the 16 data output lines.

■Interface Cable

Amplifier	Cable length	Interface Cable
V600-HAR91/81	2 m	V600-A60R
(Connector: 20 pin)
	5 m	V600-A61R
	10 m	V600-A62R
V600-HAM91/81	2 m	V600-A60M
V600-HAR92
	5 m	V600-A61M
(Connector: 26 pin)
	10 m	V600-A62M

Note: The interface cable connector is not waterproof. If there is a possibility that the connector may be exposed to water, keep it inside the control box. The maximum cable length is 10 m.

Intelligent Flag I/II V600-HA 3