Omron V600-HA specifications Circuit Configuration, Precautions, Input/Output

Circuit Configuration

V600-HAR91

V600-HAM91

Input Circuit

24 V

ON/	IN	8.2 kΩ	Main circuit
OFF
Tr
	0 V

Output Circuit

OUT

Main circuit

0 V

V600-HAR92

Input Circuit

	24 V
ON/		8.2 kΩ
	IN	Main circuit
OFF
Tr
	0 V

Output Circuit

OUT

Main circuit

0 V

V600-HAR81

V600-HAM81

Input Circuit

+DC

Tr IN

Main circuit

8.2 kΩ

0 V

Output Circuit

+DC

Main circuit

OUT

0 V

Precautions

■Cautions

!Caution

Be sure to house the V600-HA@91/-HA@81/-HA@92 together with their connectors and cable in control boxes when using them and do not expose them to water, oil, dust, metal powder, corrosive gas, or organic solvent, otherwise they may malfunction, suffer damage, or burn.

!Caution

The connectors of the V600-HA@91/-HA@81/-HA@92 can be mounted to metal plates, provided that there is an insulation plate with a thickness of 1.5 mm minimum between each of the connec- tors and metal plates.

Input/Output

The Data Input and Data Output lines are set to “1" when the transis- tor turns ON and to “0" when it turns OFF.

Do not use a solid-state output with the following ratings with the V600-HAM91/-HAM81, otherwise an external input error may result.

1.Maximum switching current: 1 A min.

2.Minimum switching current: 10 mA min.

3.Response time (ON to OFF): 3 ms min.

The following OMRON products cannot be connected to this product.

•CVM1-OD219, C20H, C28H, C40H, or C60H Programmable Controllers

•Sensor Controllers other than from the S3D2 Series

When using a contact output, pay careful attention to chattering and to the minimum switching current. Also note that the minimum switch- ing current may be specified for some solid-state outputs.

When connecting an inductive load or an electrical device that tends to generate noise to the output, connect a diode in parallel with the load. Connect the cathode side of the diode to the positive side of the power source.

	L
Open collector output	Diode	DC
		power supply

Diode

Peak inverse voltage

Minimum of three times of the load voltage

Average rectified current: 1 A

Intelligent Flag I/II V600-HA 9