One for All URC-2585 manual Helpful Hints, Problem Solution

Trouble-Shooting

Helpful Hints

Problem:	Solution:
Red light does not	Replace batteries with 4 fresh, new
blink when you press	AAA alkaline batteries.
a key?
The ONE FOR ALL	Make sure you are using new
does not respond	batteries and are aiming the ONE
after pressing a key?	FOR ALL at your device.
The ONE FOR ALL	A) Try all the codes listed for your
does not operate your	brand.
device(s)?	B) Try the search method on page
	14.
Your brand is not	Try the search method on page 14.
listed in the ONE FOR
ALL code section?
When following the	Did you use the Code Lock feature?
set-up instructions,	You must first unlock the code
the red light on the	before entering a new code. Follow
ONE FOR ALL only	the instructions on page 13 to do
blinks once instead of	this.
twice after you enter
a three-digit code?
The ONE FOR ALL is	You may be using the wrong code.
not preforming	Start the search method over again
commands properly?	to locate the proper code.
Press a key but get	Hold MAGIC until the red light
the wrong result?	blinks twice, then press 992 and the
	device key twice. You will need to
	set-up your device again. Try the
	codes for your brand or the search
	method on page 14.
You cannot control	Hold MAGIC until red light blinks
the volume feature of	twice. Then press 993 and VOL+. To
your Satellite, Cable	set the volume control back to TV
Converter or TV/	(Punch Through), hold Magic until
Video combination or	the red light blinks twice, then
you cannot control	press 993 TV.
the volume of your
TV set up on the AUX
key?
Problems changing	Enter the programme number
channels?	exactly as you would on your
	original remote.
Video not recording?	As a safety feature on your ONE
	FOR ALL, you must press the Record
	key twice.
Scan does not work	Make sure your original remote had
on your device?	a programme +/- key.

16