Onkyo instruction manual DV-SP305 work OK but Remote Those on the remote, Controller don’t?

Troubleshooting—Continued

		There are no batteries in the remote	Install new batteries (page 10).
		controller.
		The batteries are flat.	Replace with new batteries (page 10).
		The batteries are installed incorrectly.	Check the batteries and correct as necessary
			(page 10).
Controller
		You’re not pointing the remote controller	Point the remote controller at the DV-SP305’s
	Buttons on the	at the DV-SP305’s remote sensor.	remote sensor (page 10).
			Use the remote controller closer to the DV-SP305
	DV-SP305 work OK but
Remote	those on the remote	You’re too far away from the DV-SP305.	(page 10). The remote controller has a range of
	controller don’t?		approximately 5 meters.
		A strong light source is interfering with	Make sure that the DV-SP305 is not subjected to
			direct sunshine or inverter-type fluorescent lights.
		the DV-SP305’s remote sensor.
			Relocate if necessary.
		If the DV-SP305 is installed in a cabinet
		with colored glass doors, the remote con-	Open the doors, or use a cabinet without colored
		troller may not work reliably when the	glass.
		doors are closed.

Note:

•Static electricity or other external influences may cause malfunctioning of this unit. In this case, unplug the power cord and then plug back in. This will usually reset the unit for proper operation. If this does not correct the problem, please consult your nearest our customer center.

The DV-SP305 contains a microcomputer for signal processing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.

54