Troubleshooting
If you have any trouble using the
Power
Can’t turn on the
•Make sure that the power cord is properly plugged into the wall outlet (page 12).
•Unplug the power cord from the wall outlet, wait five seconds or more, then plug it in again.
•While the
Audio
There’s no sound.
•The
•The wrong input source is selected on your amplifier. Check your amplifier’s input source setting. Refer to your amplifier’s manual.
•If the DIGI OUT is set to OFF in the SETUP menu, no digital audio output is available (page 20).
CD
Can’t play a CD.
•The disc is upside down. Load the disc with the
•The disc is dirty. Remove the disc and clean it (page 23).
•Condensation has formed inside the
•The disc is nonstandard. See “Supported Discs” on page 23.
•The
CD playback skips.
•Install the
•The disc is dirty. Remove the disc and clean it (page 23).
•The disc is very scratched. Replace the disc.
Can’t enter track numbers for memory playback.
•No such track on the CD. Enter another number (page 17).
It takes a long time to locate certain tracks.
•The disc is dirty. Remove the disc and clean it (page 23).
•The disc is very scratched. Replace the disc.
SETUP
Can’t find a SETUP menu in need.
•If any track has been selected even when the
Remote Controller
The remote controller does not work.
•There are no batteries in the remote controller. Install new batteries (page 9).
•The batteries are flat. Replace with new batteries (page 9).
•The batteries are installed incorrectly. Check the batteries and correct as necessary (page 9).
•You’re not pointing the remote controller at the
•You’re too far away from the
•A strong light source is interfering with the
•If the
25