Control positions and names
Remote controller
Remote controller
1.Open/close button [8]
2.Operation buttons
: Stop button [9, 11]
: Pause button [9]
1
2
3
4
5
DISC 1
DISC 4
1
4
NEXT SELECTION
|
| DISC |
DISC 2 | DISC 3 | INTRO SCAN |
DISC 5 | DISC 6 | RANDOM |
2 | 3 | REPEAT |
5 | 6 | MEMORY |
6
7
8
9
: Play button [8~10, 13, 14]
: Fast reverse button [9, 15]
: Fast forward button [9, 15]
: Reverse skip button [11, 14] : Forward skip button [11, 14]
3. NEXT SELECTION button [12] |
6
7 | 8 | 9 | CLEAR |
|
|
| 10 |
+10 | 0 |
|
|
REMOTE CONTROLLER
Insert the batteries into the remote controller following the illustration below.
1
2
3
Remote control sensor |
30° 
30°
approx. 5 m
(16 feet)
4. | Direct play buttons |
| (DISC |
5. | Number buttons and +10 button [10, 12, 14] |
6. | DISC INTRO SCAN button [11] |
7. | RANDOM button [13] |
8. | REPEAT button [13] |
9. | MEMORY button [14, 15] |
10. CLEAR button [15]
Inserting the remote controller batteries
1.Remove the battery compartment cover by opening it as shown in the illustration.
2.Insert two AA (R6- or
3.After batteries are installed and seated correctly, replace the com- partment cover.
Notes
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if the remote controller is not to be used for a long time.
•Remove dead batteries immediately to avoid damage from cor- rosion. If the remote controller doesn’t operate smoothly, replace both the batteries at the same time.
•The life of the batteries supplied is about six months but this will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control sensor.
Notes
•Place the unit away from strong light such as direct sunlight or inverted fluorescent light which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment which uses infrared rays may cause operational interference.
•Do not put any object such as a book on the remote controller. The buttons of the remote controller may be pressed by mistake and drain the batteries.
•Make sure the audio rack doors do not have colored glass. Plac- ing the unit behind such doors may prevent proper remote con- troller operation.
•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
