Onkyo instruction manual Before Using the DX-C390, Installing the Remote Controller’s Batteries

Before Using the DX-C390

Installing the Remote Controller’s Batteries

1Remove the battery compartment cover, as shown.

Using the Remote Controller

To use the remote controller, point it at the DX-C390’s remote control sensor, as shown.

DX-C390

Remote control sensor

2Insert the two supplied batteries (AA/R6) in accordance with the polarity diagram inside the battery compartment.

30°

Notes:

30°

3Replace the battery compartment cover.

Notes:

•The batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replacing the batteries.

•Don’t mix new and old batteries or different types of batteries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent damage from leakage or corrosion.

•Flat batteries should be removed as soon as possible to prevent damage from leakage or corrosion.

•The remote controller may not work reliably if the DX-C390 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the DX-C390.

•If another remote controller of the same type is used in the same room, or the DX-C390 is installed close to equipment that uses infrared rays, the remote control- ler may not work reliably.

•Don’t put anything, such as a book, on the remote con- troller, because the buttons may be pressed inadvert- ently, thereby draining the batteries.

•The remote controller may not work reliably if the DX-C390 is installed in a rack behind colored glass doors. Keep this in mind when installing the DX-C390.

•The remote controller will not work if there’s an obsta- cle between it and the DX-C390’s remote control sen- sor.

11