Onkyo HT-S590 Turning On the AV Receiver, Smooth Operation in a Few Easy Steps

Turning On

STANDBY/ON

	STANDBY indicator
								TUNING	/ PRESET	MASTER VOLUME
STANDBY/ON
								ENTER
	STANDBY
A SPEAKERS B	TONE	+	STEREO	LISTENING MODE	DISPLAY DIGITAL INPUT	RT/PTY/TP MEMORY TUNING MODE		RETURN	SETUP
							CLEAR
PHONES
	MULTl CH	DVD	VIDEO 1/VCR	VIDEO 2	VIDEO 3	TAPE	TUNER	CD

RECEIVER

ON/STANDBY

REMOTE MODE

ON/STANDBY		RECEIVER	DVD
		TAPE
INPUT SELECTOR
1	2	3	CD
V1	V2	V3
4	5	6	MD
	MULTI CH	DVD
7	8	9	CDR
TAPE	TUNER	CD
+10	0	CLR	HDD
--/---	DIMMER	SLEEP
		CH	VOL
		DISC
		ALBUM

Turning On the AV Receiver

1

AV receiver	Remote
	controller
STANDBY/ON	RECEIVER
	or
	ON/STANDBY

Press the [STANDBY/ON] button.

Alternatively, press the remote controller’s [RECEIVER] button followed by the [ON/STANDBY] button.

The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.

To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control- ler’s [ON/STANDBY] button. The AV receiver will enter Standby mode. To prevent any loud surprises the next time you turn on the AV receiver, always turn down the volume before turning it off.

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once.

■Have you connected a component to a digital audio input?

If you have, see “Assigning Digital Inputs to Input Sources” on page 35.

■Have you connected an Onkyo MD recorder, CD recorder, or next generation HDD-compatible component?

If you have, see “Changing the Input Display” on page 35.

COAXIAL

OPTICAL

OUT IN

TAPE

CD recorder, MD recorder

Testing the speakers

To test that all of the speakers are working properly, press the remote controller’s [TEST TONE] button.

The test tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the test tone, press the [TEST TONE] button again.

•If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, you may have wired the speakers incorrectly and you should check your connections (see page 20).

•If the test tone is not produced by a speaker and its name does not appear on the display, you may have set the speaker settings incorrectly (see page 52).

34