Onkyo HT-S590 instruction manual Speaker Configuration

Cone diameter

Advanced Setup—Continued

Speaker Configuration, Crossover Frequency, and Double Bass settings only need to be changed if you’re not using the speakers in this package.

These settings cannot be changed while head- phones are connected, speaker set B is on, or the multichannel DVD input is being used.

Speaker Configuration

This section explains how to specify your speaker con- figuration.

For speakers with a cone diameter

larger than 6-1/2 inches (16 cm), specify Large (full band). For those

with a smaller diameter, specify

Small (default crossover 100 Hz). The crossover frequency can be

changed on page 53.

1Press the [RECEIVER] button fol-

RECEIVER lowed by the [SETUP] button.

SETUP

2 Use the Up and Down []/[ ] buttons to select “1. SP Config,” and then press the [ENTER] but- ton.

ENTER

3While the Subwoofer setting is

selected, use the Left and Right []/[ ] buttons to select Yes or No.

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

4

5

6

Use the Down [ ] button to select “Front,” and then use the Left and Right []/[ ] buttons to

select Small or Large.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

• If the Subwoofer setting in step 3 is set to No, this setting is fixed at Large and does not appear.

Use the Down [ ] button to select “Center,” and then use the Left and Right []/[ ] buttons to

select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

Use the Down [ ] button to select “Surround,” and then use the Left and Right []/[ ] but- tons to select Small, Large, or None.

Small: Select if the surround speak- ers are small.

Large: Select if the surround speak- ers are large.

None: Select if no surround speakers are connected.

Note:

•If the Front setting in step 4 is set to Small, the Large option cannot be selected.

Continue with step 7 of the “Crossover Frequency” setting.

52