Tape dubbing
•The recording level is automatically set to the optimum level during dubbing.
•The Dolby NR System of Deck A is automatically used to record the tape in Deck B. If you wish to monitor the signal from a Dolby NR encoded tape during dubbing, be sure to set the Dolby NR to match the type of Dolby NR with which the cassette was recorded.
|
|
|
| 1 |
|
|
| ONKYO |
|
|
|
|
|
| 2 | 3 | 4 |
1 |
|
|
|
|
|
2 |
| REVERSE MODE |
|
| |
|
|
|
|
| |
3 |
|
|
| ||
| PLAY |
|
| PLAY |
|
4 |
| DUBBING |
|
|
|
|
| NORMAL | HIGH |
|
|
Tape dubbing
1.Insert the prerecorded cassette into Deck A , and insert the cassette to be recorded into Deck B.
2.Set the Reverse Mode by pressing the REVERSE MODE button repeatedly until the desired mode is displayed.
( v ) one side: Only one side of the tape is copied.
( b ) repeat: Both sides of the tape are copied.
3.Check the Deck A and Deck B direction indicators to ensure that the tape will start in the desired direction.
•To dub an entire tape, be sure to select the forward ( s ) direction on both Decks.
•To change the setting of the Direction indicator, press the a or s button followed by the e button.
4.Begin dubbing by pressing the NORMAL or HIGH button. [NORMAL] : Normal speed dubbing
will begin.
[HIGH] : High speed dubbing about half the time normally required will begin.
DUBB.STOP
t
Stopping dubbing
Press the Deck B e (DUBB.STOP) button.
Briefly interrupting dubbing
Press the t button.
In this case, you can change the cassette in Deck A or search the desired portion by using the buttons for Deck A. To resume dubbing, press the NORMAL or HIGH button or Deck B a or s button again.
10