Onkyo TX-SR600, TX-SR700 manual 18

Connections (TX-SR700/700E)

Connecting a DVD Player with 2-Channel (L/R) Audio Output

	ANTENNA							GND
								COMPONENT VIDEO
								INPUT 2	INPUT 1	OUTPUT
						R	L			Y
	FM		AM			PHONO IN
	75
										PB
											REMOTE
										PR CONTROL
DIGITAL INPUT		DIGITAL		VIDEO 3	VIDEO 2		VIDEO 1		DVD	MONITOR	ZONE 2
		OUTPUT COAXIAL		IN	OUT	IN	OUT	IN	IN	OUT
	OPTICAL	OPTICAL									12V
2										V	TRIGGE
	1
											OUT
										S	IR
											IN
			COAXIAL
			DIGITAL
			INPUT
	IN	OUT	IN	IN	OUT	IN	OUT	IN	FRONT	SURR CENTER
	L									L
SUBWOOFER
PRE OUT
	R									R
	CD	TAPE		VIDEO 3	VIDEO 2		VIDEO 1			SUB
										WOOFER

DVD

: Signal flow

4. Connecting a DVD player (DVD)

Using an RCA video cable, connect the video output jack (composite) of the DVD player to the DVD VIDEO IN jack of the TX-SR700/ 700E. Or if the DVD player has an S video output jack, connect it to the DVD S VIDEO IN jack with an S video cable. Or if the device has component video outputs, connect them to the COMPONENT VIDEO INPUT 1 or 2 jacks on the TX-SR700/700E.

With the initial settings of the TX-SR700/700E, the DVD input source is set for the COMPONENT VIDEO INPUT 1 jacks.

If you connect the DVD player to the COMPONENT VIDEO INPUT 2 jacks, this must be changed at “Input Setup” → “Component Video” (see page 54).

Using an RCA audio connection cable, connect the audio output jacks of the DVD player to the DVD FRONT L/R jacks of the TX- SR700/700E. Make sure that you properly connect the left channel to the L jack and the right channel to the R jack.

If the device has a 5.1-channel output, connect the DVD FRONT L/ R, SURR L/R, CENTER, and SUBWOOFER (5.1-channel input) jacks of the TX-SR700/700E to the 5.1-channel output jacks of the DVD player. Make sure that you properly connect the left channels to the L jacks and the right channels to the R jacks.

If the device has a digital output, connect it to either the DIGITAL INPUT COAXIAL jack or the DIGITAL INPUT OPTICAL jack of the TX-SR700/700E depending on the type of connector on the DVD player.

With the initial settings of the TX-SR700/700E, the DVD input source is set for digital input at the COAXIAL jack (COAX).

If the digital connection is made at a different jack, this must be changed at “Input Setup” → “Digital Input” (see page 53).

Note:

If the DVD player has both 5.1-channel audio outputs and 2-channel audio outputs, and you want to connect the DVD player only using the FRONT L/R jacks on the TX-SR700/700E, use the 2-channel audio output jacks on the DVD player.

Y

PB Component video output

PR

Video ouput

S video output

4. DVD player (DVD)

L (white)

Analog audio output R (red)

Digital audio output (coaxial)

18