Recording
Can’t record?
•On your recorder, make sure the correct input is selected.
•To prevent signal loops and damage to the AV receiver, input signals are not fed through to outputs with the same name (e.g., TAPE IN to TAPE OUT, or VIDEO 1 IN to VIDEO 1 OUT).
Others
The sound changes when I connect my head- phones?
•When a pair of headphones is connected, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct.
How do I change the language of a multiplex source?
•Use the “Multiplex” setting on the “4. Audio Adjust” menu to select Main or Sub (page 48).
The 
functions don’t work?
•To use 
, you must make an 
connection and an analog audio connection (RCA) between the compo- nent and AV receiver, even if they are connected digi- tally (page 31).
The AV receiver contains a microcomputer for signal pro- cessing and control functions. In very rare situations, severe interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely event that this happens, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Onkyo is not responsible for damages (such as CD rental fees) due to unsuccessful recordings caused by the unit’s malfunction. Before you record important data, make sure that the material will be recorded cor- rectly.
Before disconnecting the power cord from the wall out- let, set the AV receiver to Standby.
57
