OPEN303W
User Guide
Appendix
Soft AP Configuration
Setup Requirement:
To bridge your wired and wireless network using 802.11b+g Wireless LAN USB Adaptor, the following must be met:
ëíÉé=N Install the 802.11b+g Wireless LAN USB Adaptor on the
ëíÉé=O The Soft Access Point should be connected to a network switch, hub or a Broadband Router. Use a standard Category 5 UTP Ethernet cable with an RJ- 45 connector to connect the Soft Access Point to one of router, hub, or switch.
ëíÉé=P The computer that you are installing the wireless card into has an Ethernet connection, and is connected to a LAN with a DHCP server.
SoftAP Configuration
ëíÉé=N Select the Access Point mode, and you will see the following figure
ëíÉé=O Click the More Setting… button and the following figure will appear for you to configure
ëíÉé=P Select the wired Network Adaptor that has already installed in the COMPUTER from the
ëíÉé=Q If the network connected to the wired LAN card has a DHCP server, you just need to configure the wireless station as a DHCP client (select Obtain an IP address automatically). If the network does not have a DHCP server, you must assign a fixed IP to the wired computer (select Use the following IP address).
14