then shows the clock.
RESETTING THE STEREO
If your stereo locks up or does not work properly, use something pointed, such as a straightened paper clip, to press RESET for about 1 second.
TURNING THE STEREO'S BEEP ON AND OFF
The stereo normally beeps when you press most buttons. To turn the stereo's beep on or off, eject a CD if loaded. Then press and hold down CD for about 3 seconds until the
display turns off then on again.
RADIO OPERATION
PLAYING THE RADIO
1.Press ON/OFF to turn on the stereo. The radio automatically tunes to the last station and bank selected.
2.Press BAND to select the desired band. AM appears on the display when the AM band is selected. FMI or FMII appears on the display when an FM band is selected.
3.Tune to the desired station one of the following ways. Manual Tuning:
Repeatedly press TUNE/SEEK TRACK - or + to tune down or up the selected band.
Seek Tuning:
Press and hold down TUNE/SEEK TRACK - or + for about 1 second to tune to the next lower or higher station.
Note:
If DX appears on the display, the stereo stops on both strong and weak FM stations. To limit seek tuning to only strong FM stations, press LO/DX so DX disappears.
4.Press AUDIO CONTROL + or - to increase or decrease the volume as desired.
