terminal.
2.If you secured the stereo to an existing mounting hole under the dash, slide the stereo to the right or left to free the mounting bolt from the mounting hole.
Otherwise, remove the bolt holding the metal strap attached to the back of the stereo.
3.Press RLS to remove the stereo's control panel.
4.Insert both of the supplied keys into the slots at the left and right sides of the stereo. Press the keys downward and slide the stereo out of the dash.
5.Remove the keys from the slots.
6.Disconnect the wire harness and the antenna.
7.If you are mailing or shipping the stereo, use a small Phillips screwdriver to reinstall the shipping screw in the top of the stereo.
6.Reconnect the cable to the vehicle battery's negative
USING THE CONTROL PANEL
The stereo's control panel must be in place for the stereo to operate. When you remove it, the display turns off and the stereo cannot be used. This is a simple, but effective security measure.
Note:
Any stored stations remain in memory when the control panel is removed.
INSTALLING THE CONTROL PANEL
1.Insert the left edge of the control panel into the left edge of the recess. Make sure the pins in the recess fill the holes in the edge of the control panel.
2.Gently push the right edge of the control panel into the recess until you hear a click.