CONNECTING TO AN AUDIO OUTPUT COMPONENT
To hear the music along with your voice, connect your stereo amplifier/receiver to the karaoke’s OUT L and R jacks using the supplied cable. Use the white plug for the left connection and the red plug for the right connection at both ends of the cable.
|
|
| R IN L | OUT |
. | B |
| CD | L |
DC 6V | • | TAPE | R | |
MAX. 50mA |
Audio Output Jacks
Note: If you turn off the karaoke, the sound from the audio source still passes through the karaoke to the audio output component unaffected until you turn off the source and/or the output compo- nents.
Caution: If you connect the karaoke’s input and output to the same audio com- ponent (like a tape deck monitor circuit in a receiver), the karaoke cannot isolate the ground to the input jacks. This caus- es the right channel to short to ground and feed the left channel to both the left and right outputs.
CONNECTING POWER
You can power your karaoke system us- ing one of the following power sources.
•four AA batteries
•AC power
Installing Batteries
You can power the karaoke system with four AA batteries (not supplied). For the longest life and best performance, we recommend RadioShack alkaline batter- ies.
Cautions:
•Use only fresh batteries of the required size and recommended type.
•Do not mix old and new batteries, different types of batteries (stan- dard, alkaline, or rechargeable), or rechargeable batteries of different capacities.
Follow these steps to install the batter- ies.
1.Rotate ECHO counterclockwise to- ward POWER until it clicks to turn it off.
POWER
ECHO
2.Press on the battery compartment cover on the bottom of the karaoke and slide it in the direction of the arrow to remove it.
5