Optimus STAV-3370 Using the Remote Control, AUDIO/VCR Switch, Receiver/Amplifier Section

Using the Remote Control

The remote control works up to a distance of about 23 feet, and within a 30- degree angle on either side of the receiver. Point the control at the receiver’s front panel and press the desired button(s).

Many buttons on the remote control work the same as buttons on the receiver’s front panel. Use these buttons exactly as you would use the corresponding but- tons on the receiver.

AUDIO/VCR Switch

The remote control can also control other compatible audio/video components when you connect them to the receiver’s CONTROL OUT jack. Set the switch to AUDIO to control audio components such as CD players or cassette decks. Set the switch to VCR to control video components such as a VCR.

When you set the switch to VCR, dual-function buttons control the function marked in gold next to the button. For example, the button marked CENTER MODE and TEST TONE operates as the center mode adjust when you set the switch to AUDIO and as the delay time function when you set the switch to VCR.

Receiver/Amplifier Section

FUNCTION	Selects a program source (VCR/Tape 1, LD, CD, tuner, or
	phono). Repeatedly press FUNCTION until the display shows
	your desired program source. See Page 14.

–MASTER VOLUME + Adjusts the system’s volume. See Page 14.

CENTER MODE	Selects among the three center mode settings with AUDIO/
	VCR set to AUDIO. See Page 21.
– CENTER +	Controls the relative volume of the center speaker with
	AUDIO/VCR set to AUDIO. See Page 21.
– REAR +	Controls the relative volume of the rear speakers with
	AUDIO/VCR set to VCR. See Page 21.
TEST TONE	Sounds test tones from each speaker with AUDIO/VCR set to
	VCR. See Page 21.
DELAY TIME	Sets the rear-channel delay for Dolby Pro-Logic Surround
	and Simulated Surround programs with AUDIO/VCR set to
	VCR. See Page 21.
SURR MODE	Selects between Dolby Pro-Logic Surround or Simulated Sur-
	round sound. See Page 20.
SLEEP	Sets the receiver to turn off after 90, 60, or 30 minutes with
	AUDIO/VCR set to AUDIO. To start the timer, repeatedly
	press SLEEP until the desired turn-off time (90, 60, or 30)
	appears. To cancel the timer, repeatedly press SLEEP until
	the sleep time disappears from the display. See Page 17.
RECEIVER POWER	Turns the receiver on and off. See Page 14.
RETURN	Returns the receiver to its default settings. See Page 27.
3CH LOGIC	Selects Dolby 3CH Logic. See Page 20.
TAPE 2 MONITOR	Switches the receiver to monitor the source connected to the
	TAPE 2 MONITOR jacks. See Page 18.

22