Placement of speakers, Demo function | Panasonic SC-VK660 instruction

DANSK

FRANÇAIS

Simple setup (continued)

Placement of speakers

Place the subwoofer on the ﬂ oor or a sturdy shelf so that it will not cause vibration.

Front speaker	Main	Front speaker
(left)	unit	(right)
		Subwoofer

Front speakers

Speakers are designed identically so that no left or right channel orientation is necessary.

You cannot take the front net off the speakers.

Use only the supplied speakers

•The combination of the main unit and speakers provide the best sound. Using other speakers can damage the unit and sound quality will be negatively affected.

•Set the speakers up on an even surface to prevent them from falling. Take proper precautions to prevent the speakers from falling if you cannot set them up on an even surface.

Positioning for best effect

How you set up your speakers can affect the bass and the sound ﬁ eld. Note the following points.

•Place speakers on ﬂ at secure bases.

•Placing speakers too close to ﬂ oors, walls, and corners can result in excessive bass. Cover walls and windows with a thick curtain.

If irregular coloring occurs on your television

These speakers are designed to be used close to a television, but the picture may be affected with some televisions and set-up combinations.

If this occurs, turn the television off for about 30 minutes.

The television’s demagnetizing function should correct the problem. If it persists, move the speakers further away from the television.

Note:

•Keep your speakers at least 10mm away from the system for proper ventilation.

•You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

•Reduce the volume in the following cases to avoid damage.

−When playing distorted sound.

−When the speakers emit strange noise (howling) from a microphone or record player, noise from FM broadcasts, or continuous signals from an oscillator, test disc, or electronic instrument.

−When adjusting the sound quality.

−When turning the unit on or off.

Caution

•Use the speakers only with the recommended system. Failure to do so can damage the ampliﬁer and speakers, and can cause ﬁre. Consult a qualiﬁed service person if damage occurs or if a sudden change in performance is apparent.

•Do not attach these speakers to walls or ceilings.

LANG - 4

Preparing the remote control

Insert so the poles (+ and –) match those in the remote control.

R6/LR6, AA

• Do not use rechargeable type batteries.

Do not:

•mix old and new batteries.

•use different types of the batteries at the same time.

•heat or expose batteries to ﬂ ame.

•take apart or short circuit the batteries.

•attempt to recharge alkaline or manganese batteries.

•use batteries if the covering has been peeled off.

Mishandling of batteries can cause electrolyte leakage which can severely damage the remote control.

Remove the batteries if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

■Use

Aim at the remote control signal sensor (\ page 8), avoiding obstacles, at a maximum range of 7 m directly in front of the unit.

LANG - 5

RQTV0238

DEMO function

DISPLAY, -DEMO

When the unit is ﬁ rst plugged in, a demonstration of its functions may be shown on the display.

If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

Press and hold [DISPLAY, -DEMO].

The display changes each time the button is held down.

DEMO OFF DEMO ON

While in standby mode, select “DEMO OFF” to reduce power consumption.