Note
The screws on the lamp cover and the lamp cannot be removed.
The projector cannot be turned on if the lamp cover has not been placed back on the projector.
Do not touch the glass area of the lamp. Hand oil can cause the lamp to shatter. Use a dry cloth to clean the lamp module if it was accidentally touched.
ppendices
1
2 | English |
|
3 
Lamp Replacement Procedure: 
1.Switch off the power to the projector by pressing the “
” button.
2.Allow the projector to cool down for at least 30 minutes.
3.Disconnect the power cord.
4.Unscrew the two screws on the cover. 1
5.Lift up and remove the cover. 2
6.Unscrew the two screws on the lamp module. 3
7.Lift up the lamp handle and remove the lamp module slowly and carefully. 4 To replace the lamp module, reverse the previous steps.
8.Turn on the projector and use “Lamp Reset” after the lamp module is replaced.
Lamp Reset: (i) Press “Menu” (ii) Select “SYSTEM” (iii) Select “Lamp Settings” (iv) Select “Lamp Reset” (v) Select “Yes”.
43
