Frequency Search
Should the receiver not respond to the controller after installing the driver see “Installing the Wireless USB Receiver” on page 7, reset the transmission and reception frequency between controller and wireless USB receiver using the following procedure.
1Plug the wireless USB receiver into an available USB port.
2Press the Connect Key on the wireless USB receiver. The Status LED starts flashing. If the frequency search is not complete within 1 minute, the LED will still stop flashing.
3Remove the battery on the LR4.
4Press the Power button while
While inserting the battery, the LCD screen lights up for 1 second and then go out.
5Release the Power button after the LCD screen goes out. The Status LED will go out at the same time.
6The wireless transmission is reset. Now the LR4 is ready to use.
