Assembly
To Replace Filter
Dust Bag
To assist you in identifying components of your vacuum, the parts have been numbered as follows:
1 Handle tube, upper
2 Tube, lower
3Power head
4Outer bag
5 Paper filter dust bag 5
6Power cord
7Retaining spring
8Bag tension bar
9Zip fastener
10On/off switch
11Cord hook
12Plastic loop/cable clamp
13Connector assembly
14Fan housing
15Cord assembly
10 |
|
9 | 11 |
| |
12 | 1 |
|
4 13
|
| 2 | 6 |
8 | 7 | 14 | 15 |
| |||
|
|
| |
| 3 |
|
|
WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
1.Unsnap bag door from base.
2.Gently pull bag from
cardboard collar upwards.
1 | Before assembling appliance, |
| remove two screws from |
| connector assembly. Remove |
| cardboard insert by pulling |
| upward. |
3. Dust seal will close automatically
BAG INSTALLATION:
1. Slide the cardboard collar completely onto bag dock door.
2 |
3 |
With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Insert short screw into top hole and long screw into bottom hole then tighten firmly until handle is no longer loose.
Attach cord assembly to cord clip by pressing cord above and below clip ensuring the cord is fully rested in clip.
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
2.Firmly push bag dock door with both thumbs on indication point until
it snaps.
4