Bryant manual 582A018-060 208/230-1, Typical Wiring Schematic

LEGEND

TYPICAL WIRING SCHEMATIC,

18

BR — Blower Relay

C— Contactor

CAP — Capacitor

COMP — Compressor Motor

CR	—	Combustion Relay
EQUIP	—	Equipment
FS	—	Flame Sensor
FU	—	Fuse
GND	—	Ground
GVR	—	Gas Valve Relay
HS	—	Hall Effect Sensor
HV	—	High Voltage Transformer
TRAN

I— Ignitor

IDM	—	Induced-Draft Motor
IFM	—	Indoor-Fan Motor
IGC	—	Integrated Gas
		Unit Controller
LS	—	Limit Switch
MGV	—	Main Gas Valve
NEC	—	National Electrical Code
OFM	—	Outdoor-Fan Motor
QT	—	Quadruple Terminal

RS	— Rollout Switch
ST	— Thermistor Start
TRAN	— Transformer
	Field Splice
	Terminal (Marked)
	Terminal (Unmarked)
	Splice
	Splice (Marked)
	Factory Wiring
	Field Control Wiring
	Field Power Wiring
	Accessory or
	Optional Wiring
	To Indicate Common
	Potential Only: Not to
	Represent Wiring

582A018-060; 208/230-1-

NOTES:

1.If any of the original wires furnished are replaced, they must be re- placed with type 90 degree C wire or its equivalent.

2.See price pages for thermostat and subbases.

3.Use 75 degree C copper conductors for field installation.

4.For high speed IFM, disconnect RED wire from IGC:BM and connect BLK wire from IFM. For medium speed, disconnect RED wire from IGC:BM and connect BLU wire from IFM.

5.Models 582A018-042 have LS1 and LS2 wired in series. Models 582A048,060 have LS1 only.

60