
E N G L I S H
Maintenance
Trouble- shooting
Service problems that appear to be major can often be solved easily.
You can be your own troubleshooter by reviewing this guide.
All other servicing should be done by an Oreck authorized service center.
Stuffing or Blockage
IMPORTANT: On plush and new carpets, stuffing may occur inside the intake tube and the lower tube assembly. This is due to excessive fuzz and loose cuttings in the carpet. Stuffing could occur for the first few cleanings until all the loose material is removed. Due to the high efficiency of the cleaner, many older carpets will cause stuffing when the cleaner is first used on them. If your vacuum cleaner does not pick up properly, or makes unusual noise and the outer bag does not fluff up or balloon open, follow these steps:
WARNING: Unplug cord from electrical outlet before servicing.
23Check for blockage at the mouth of the intake opening. If there is blockage, remove it with
24If the blockage is not at the base, remove lower tube. Unhook bag spring, releasing bottom of bag.
25Twist lower collar counterclockwise to slide up. Pull tube out of base.
26Check for blockage. If blockage is in the tube, remove with a coat hanger.
27If tube is not blocked, look into fan housing. Remove debris with
25To reassemble, check
Reattach bag spring.
28Many times blockage occurs due to a full dust bag causing dirt to back down the air flow system. When that happens, the blockage will be at the top of the system, starting in the area where the dust bag connects to the connector assembly.
Note: If the above actions do not correct the problem, contact an Oreck authorized service center or call the
customer service center. US:
23 | 24 | 25 | 26 | 27 | 28 |
Problem | Check |
| What to do |
|
|
Cleaner will not run. | •Not plugged in properly. | •Be sure cleaner is firmly plugged into wall outlet. |
•No electricity in wall outlet. •Check electrical source – fuse or circuit breaker.
Cleaner does not pick up. | •Inner Bag is full. | •Replace filter bag. See “Replacing the HEPA |
|
| Filtration Odor Fighting Inner Bag”. |
| •Nozzle or intake pivot | •Clear obstruction. |
| clogged. |
|
| •Belt is broken or stretched. | •Replace belt. |
| •Brush is worn. | •See “Adjusting or Replacing Brush roll”. |
| •Bag tube clogged. | •Clear obstruction. |
| •Bag pores are clogged | •Change bag. |
| with fine dust. |
|
| •Impeller fan is broken. | •Return to Service Center for repair. |
|
|
|
Unit still does not | •Check all the | •Contact Oreck for service. |
operate properly. | above points. |
|
8