E N G L I S H
Replacing Filter Bag
Check bag frequently or when dustbag full indicator indicates dust bag is full.
Note: If picking up heavy debris, change bag more frequently.
BAG FULL
INDICATOR
Switch the unit off. Unplug unit from wall outlet. Open the cover by lifting the latch in front of the intake.
Remove dust bag by raising handle on bag carrier and lifting carrier out.
Remove the bag from carrier by pulling the cardboard tag. The Saniseal™ dust seal will close automatically.
Insert a new bag into carrier by sliding cardboard into slots on carrier until bag is fully inserted. Bend rear part of dustbag downwards.
Replace the carrier into the unit.
Close the cover by pressing it down until it latches. The cover cannot be closed if a bag is not present or inserted properly.
Replacing Motor Filter
Unplug unit from wall outlet. Remove the dustbag and carrier to access the motor filter grill.
Using the tab located at top of filter grill, lift filter grill out of unit.
Remove filter from grill and replace with new filter. Change the motor filter every fifth dustbag replacement.
Replacing Exhaust Filter
Unplug unit from wall outlet. Remove exhaust grill from back of unit by pressing down and pulling out on the tab located at the top of the grill.
Discard used exhaust filter. Place new filter in grill. Set grill tabs in slots. Press top of grill to snap closed. The exhaust filter should be changed with every fifth dustbag replacement.
Note: Exhaust filter not needed if Advanced Hepa Filter was purchased.
6
