Oreck XL2100HH Assembly, Operating Instructions, E N G L I S H, To Operate, General Information

E N G L I S H

Assembly

To assist you in identifying components of your vacuum, the parts have been numbered as follows:

3	Attach cord to cord clip by
	pressing cord above and
	below clip ensuring the cord
	is fully rested in clip.

1Handle section, upper

2Tube, lower

3Power head

4Outer bag

5Paper filter dust bag

6Power cord

7 Retaining spring 5

8Bag tension bar

9Zip fastener

10On/off switch

11Cord hook

12Plastic loop/cable clamp

13Connector assembly/ cord wrap

14Fan housing

15Cord assembly

1

10
9	11
12	1

413

		2	6
8	7	14	15

3

Before assembling appliance, remove two screws from the connector assembly. Remove cardboard insert by pulling upward.

Operating Instructions

To Operate

Make sure disposable paper filter dust bag is in place. DO NOT operate the cleaner without a paper filter dust bag. Plug the power cord into an electrical outlet and press the On (l) - OFF (O) switch on Helping Handle Assembly.

General Information

The performance of your new cleaner greatly depends upon care and maintenance. The instructions in this manual will guide you in performing basic care and maintenance. To obtain the most satisfying years of service, read the instructions and keep them handy for future reference.

Operating Recommendations

This new ORECK XL High-Speed Upright is one of the finest, fastest, and strongest units in its class. You’ll love the way it cleans, gets under things, and it’s SO lightweight and easy to use.

The following are a few simple suggestions regarding its operation:

1.	When inserting a new disposable paper filter dust bag—
	FIRST PUFF OUT and OPEN THE BAG.
2.	When the disposable filter dust bag is full, REPLACE IT.
3.	If at any time the machine does not pick up properly or
	makes an unusual noise, STOP OPERATION and service.
4.	Although your upright will pick up pins, paper clips, and
	other small objects, it is recommended that these be
	removed from the floor before you vacuum. Failure to do so
	may result in permanent damage to the motor suction fan
	and its housing.
5.	WARNING: Do not use your vacuum cleaner on damp or

2	Upper
	Handle
	Connector
	Assembly

With ON/OFF switch facing the front of the unit, slide upper handle section over matching section of the connector assembly. Hold handle brace against upper handle and align screw holes. Insert short screw into top hole and long screw into the bottom hole then tighten firmly until handle is no longer loose.

wet surfaces. This will cause damage to the vacuum cleaner

and is dangerous to the user. Damage caused by use on wet

or damp surfaces is not covered under warranty.

4