Oregon RM382P user manual Temperature, Reset, Precautions, To use the projector remotely

To use the projector remotely:

1.Make sure the projection unit has been fully charged (see Power section).

2.Twist open the projection unit and press , the projection beam should now be displayed.

3.Close the projection unit and twist until it clicks shut.

4.Twist the closed projection unit to adjust the focus.

NOTE Whenever you open the projection unit you will need to adjust the focus of the projection once you have closed it.

To change the projection angle:

Place the unit on 1 of the 3 flat circles on its base to display the time vertically at 3 different angles.

TEMPERATURE

To change the indoor temperature unit on the display, press °C / °F on the base of the main unit.

RESET

To return the unit to the default settings, insert a blunt stylus into the RESET hole on the base of the main unit or on the inside of the projection unit.

PRECAUTIONS

This unit is engineered to give you years of satisfactory service if you handle it carefully. Here are a few precautions:

EN

•	Placement of this product on wood surfaces with
	certain types of finishes, such as clear varnish, may
	result in damage to the finish. Consult the furniture
	manufacturer’s care instructions for direction as to
	the types of objects that may safely be placed on
	the wood surface. Oregon Scientific shall not be
	responsible for any damage to wood surfaces from
•	contact with this product.
	Do not cover the ventilation holes. Make sure
	items that are nearby such as newspapers,
	tablecloths, curtains etc cannot accidentally cover
•	the ventilation holes.
	Do not immerse the unit in water. If you spill liquid
•	over it, dry it immediately with a soft, lint-free cloth.
	Do not clean the unit with abrasive or corrosive
	materials. This may scratch the plastic parts and
•	corrode the electronic circuit.
	Do not subject the unit to excessive force, shock,
	dust, temperature or humidity, which may result in
	malfunction, shorter electronic life span, damaged
•	battery and distorted parts.
	This product may malfunction if electrostatic
	discharge or radio interference appears in the
	environment and / or affects the ac power line. The
	unit will revert to normal operation when interference
•	stops.
	Do not tamper with the unit’s internal components.
	Doing so will invalidate the warranty on the unit and
	may cause unnecessary damage. The unit contains
•	no user-serviceable parts.
	Only use fresh batteries as specified in the user’s
7

RM382P_M_EN_OP_REVISED1.indd 7

4/19/06 6:03:42 PM