REMOTE SENSOR (THN122N)
This product is shipped with a THN122N Thermometer Sensor that collects Temperature data. Data can be collected from up to 3 sensors. Additional sensors sold separately.
SETUP SENSOR
1.Open the remote sensor battery compartment with a small Phillips screwdriver.
2.Insert the batteries, matching the polarity (+ and
SWITCH | OPTION |
|
|
Channel | Channel |
| one sensor, select a different channel |
| for each sensor. |
|
|
3.Set the channel. The switch is located in the battery compartment.
4.Place the sensor near the main unit. Press RESET on the sensor. Then, press and hold MEM and CHANNEL on the main unit to initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the Data Transmission section for more information.)
5.Close the remote sensor battery compartment.
6.Secure the sensor in the desired location using the wall mount or table stand.
Installing the batteries:
For best results:
¥Insert the batteries and select the channel before you mount the sensor.
¥Place the sensor out of direct sunlight and moisture.
¥Do not place the sensor more than 30 metres (98 feet) from the main (indoor) unit.
¥Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.
EN
¥Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
¥Position the sensor close to the main unit during cold winter months as
You may need to experiment with various locations to get the best results.
DATA TRANSMISSION
Data is sent from the sensor(s) every 40 seconds. The reception icon shown in the Temperature Area shows the status.
ICON | DESCRIPTION | ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Main unit is searching for |
|
|
|
|
|
|
|
|
| sensors. |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| At least 1 Channel has been |
|
|
|
|
|
|
|
|
| found. |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Channel 1 is selected |
|
|
|
|
|
|
|
|
| (number will change |
|
|
|
|
|
|
|
|
| depending on the sensor |
|
|
|
|
|
|
|
|
| you select). |
|
|
|
|
|
|
|
|
|
|
The selected sensor cannot | |||||||||
Temp Area | be found. Search for the | ||||||||
|
|
|
|
|
|
|
|
| sensor or check batteries. |
|
|
|
|
|
|
|
|
|
|
SEARCH FOR SENSOR
To search for a sensor, press and hold MEM and CHANNEL (on the main unit) for 2 seconds.
NOTE If the sensor is still not found, check the batteries, obstructions, and remote unit location.
NOTE Signals from household devices such as doorbells, electronic garage doors, and home security systems may cause temporary reception failure. This is normal and does not affect general product performance. The reception will resume once the interference ends.
5
