EN |
|
|
| SWITCH CLOCK DISPLAY | |
|
| |
|
| Press MODE to toggle between Clock with Seconds and |
|
| Clock with Weekday display. |
ALARM
This product is equipped with a
VIEW ALARM SETTINGS
Press | . The alarm time and alarm status will show | ||
in the Clock Area. |
| ||
|
| ||
SET ALARM |
| ||
1. | Press | to switch to alarm display. | |
2. | Press and hold | again for 2 seconds. The alarm | |
| settings will blink. |
| |
3. | Select the hour and minute. Press or to change | ||
| settings. Press | to confirm. |
ACTIVATE ALARM
Press to activate or deactivate the alarm. shows in the Clock / Alarm Area when the alarm is activated.
SILENCE ALARM
When the alarm time is reached, the crescendo alarm will sound for 2 minutes. To silence the alarm:
•Press SNOOZE / LIGHT to silence it for 8 minutes.
OR
•Press any key except SNOOZE to mute the alarm and activate it again after 24 hours.
If no button is pressed, the alarm will automatically silence after 2 minutes. It will then sound again after 8 minutes.
BAROMETER
This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast and a trend line showing the direction of barometric change. Barometric changes are measured by the main (indoor) unit.
BAROMETRIC TREND
TREND | DESCRIPTION |
|
|
| Rising |
|
|
| Steady |
|
|
| Falling |
|
|
SET UNIT AND ALTITUDE
You can set the barometric unit of measurement (mb / hPa or inHg) and altitude. Doing this allows the product to take more accurate barometric measurements.
1.Press PRESSURE to select the unit of measurement: mb / hPa or inHg.
2.Press and hold PRESSURE for 2 seconds.
3.Select the altitude
WEATHER FORECAST
This product forecasts the next 12 to 24 hours of weather within a
SUNNY | PARTLY | CLOUDY | RAINY |
| CLOUDY |
|
|
TEMPERATURE AND HUMIDITY
This product can display current, minimum, and maximum temperatures and humidity percentage information collected by the remote sensors and main (indoor) unit.
Outdoor data is collected and displayed every 40 seconds. Indoor data is collected and displayed every 10 seconds.
SELECT TEMPERATURE UNIT
Slide the °C / °F switch into the desired location. The switch is located on the front button panel. The setting for the main unit overrides the remote sensor setting.
SELECT CHANNEL NUMBER
Press CHANNEL to switch between sensors
The icon shows the selected sensor.
KINETIC- |
|
|
|
|
WAVE |
|
|
|
|
ICON |
|
|
|
|
DESIG- | Indoor | Remote | Remote | Remote |
NATED | Display | Display | Display | Display |
DISPLAY |
| Channel 1 | Channel 2 | Channel 3 |
|
|
|
|
|
To
NOTE If you use a sensor that collects only temperature data, humidity will not be shown.
NOTE For more information on the sensor see "Remote Sensor THGR122NX" Section.
6