Oregon Scientific EMR899HGN user manual Getting Started, HOW to Check Remote Indoors Temperatures

GETTING STARTED

Once batteries are placed in a given remote sensor unit, it will start transmitting information at 40-second intervals.

Also, for approximately a 3-minute duration, the main unit will automatically search for signals once batteries are installed. Upon successful reception, the individual channel temperature reading will be displayed on the top line and the respective humidity reading on the bottom line. The main unit will automatically update its readings at about 40-second intervals.

If no signals are received, blanks “ ---” will be displayed and the kinetic wave icon will not show.

To force a signal search:

•Press and hold IN/REMOTE for 2-seconds to enforce a 3-minute search.

This is useful in synchronizing the transmission and reception of the remote and main units.

Repeat this step whenever you find discrepancies between the reading shown on the main unit and that on the respective remote unit.

EN

Kinetic-wave
Icon
Designated	Indoor	Remote	Remote	Remote
		Display	Display	Display
Display	Display
		Channel One	Channel Two Channel Three

To display temperature / humidity readings from the main unit:

•Press IN / REMOTE until a dot is displayed in the box under the kinetic-wave.

To display temperature / humidity readings from a remote sensor:

•Press CHANNEL until the appropriate remote sensor channel is displayed in the box under the kinetic-wave.

If no readings are received form one particular channel for more than 15 minutes, blanks “ ---” will be displayed until further readings are successfully searched. Check the remote sensor to ensure that it is secure and that the correct channel has been selected. Optionally, press and hold IN/REMOTE for 2-seconds to enforce a search.

HOW TO CHECK REMOTE AND

INDOORS TEMPERATURES

Display of readings from a remote sensor or the main unit is a one- step procedure. The remote sensor channel or the main unit display is indicated in a box under the kinetic-wave icon.

HOW TO READ

THE KINETIC-WAVE DISPLAY

The kinetic-wave display shows the signal-receiving status of the main unit. There are three possible forms:

5

EMR899_EN_R3 5 8/30/04, 11:36 AM