Note:
The temperature range is from
If this is the first time you set the limits, the lower limit will start from
The humidity range is from 2% to 98%.
If this is the first time you set the limits, the lower limit will start from 2% and the upper limit 98% Otherwise, the reading will start from the humidity last selected.
3.Repeat the steps to set the upper humidity setting and the lower temperature and humidity settings.
4.When finished, press HI/LO to set another limit or wait
If in another channel other than channel one is selected, when the alarm activates the display will switch to
Note: If a second limit is passed while an alarm is active, the first alarm will complete its
To disable an alarm:
1.Enter the setting mode by pressing HI/LO.
2.Then, press AL ON/OFF.
The alarm has been disabled and will not sound at the previously set limit.
To disable a sounding alarm:
• Press any button, the alarm sound will stop.
DISCONNECTED SIGNALS
If without obvious reasons the display for a particular channel goes blank, press IN/REMOTE to enforce an immediate search.
If that fails, check:
1.The remote unit of that channel is still in place.
2.The batteries of both the remote unit and main unit. Replace as necessary.
Note that when the temperature falls below freezing point, the batteries of outdoor units will freeze, lowering their voltage supply and the effective range.
3.The transmission is within range and path is clear of obstacles and interference. Shorten the distance when necessary.
8
